Difference between revisions of "FlexyDually Extruder TAZ 5"

From makerspace.tulane.edu
Jump to navigation Jump to search
Line 1: Line 1:
[[File:LulzBot-FlexyDually-Mounted.JPG|200px|thumb|right|Example Image of FlexyDually Dual Extruder]]
+
[[File:LulzBot-FlexyDually-Mounted.JPG|250px|thumb|right|Example Image of FlexyDually Dual Extruder]]
 
The LulzBot TAZ 5 with the FlexyDually extruder has the advantage that it is able to print two filaments at once: one being a standard, hard plastic filament, for example [[ABS]] or [[PLA]], and the other a flexible filament, such as a dissolvable support material, like [[PVA]], or a rubber-like flexible material, like [[NinjaFlex]].
 
The LulzBot TAZ 5 with the FlexyDually extruder has the advantage that it is able to print two filaments at once: one being a standard, hard plastic filament, for example [[ABS]] or [[PLA]], and the other a flexible filament, such as a dissolvable support material, like [[PVA]], or a rubber-like flexible material, like [[NinjaFlex]].
  
Line 27: Line 27:
  
 
== Recommended Print Configurations ==
 
== Recommended Print Configurations ==
 
+
[[FlexyDually Extruder TAZ 5 Print Configurations]]
 
== Diagnostic Procedures and Information ==
 
== Diagnostic Procedures and Information ==

Revision as of 12:06, 29 September 2015

Example Image of FlexyDually Dual Extruder

The LulzBot TAZ 5 with the FlexyDually extruder has the advantage that it is able to print two filaments at once: one being a standard, hard plastic filament, for example ABS or PLA, and the other a flexible filament, such as a dissolvable support material, like PVA, or a rubber-like flexible material, like NinjaFlex.

Printing with this printer should be considered more advanced, and for most prints, the additional features are likely unnecessary. Additional configuration is necessary in Cura in order to properly use this printer.

Note that g-code prepared for the Hexagon Extruder TAZ 5 will NOT behave the same on this printer. Prints will have to either be re-plated in Cura using the correct machine profile, or the g-code will have to be manually edited.

Cura Configuration

Open the LulzBot version of Cura and follow the following steps:


Click the "Machine" drop-down menu and select "Add New Machine".

Select "LulzBot TAZ 4 or 5" and click next.

Select "Modified LulzBot TAZ 4 or 5" and click next.

Select "PEI" and click next.

Select "v1 (Budaschnozzle)" and click next.

Select "FlexyDually v1" and click next.

Click "Skip upgrade" and "Yes" on the warning that pops up.

Click "Finish".

Recommended Print Configurations

FlexyDually Extruder TAZ 5 Print Configurations

Diagnostic Procedures and Information