Difference between revisions of "Ultimaker 2 Print Configurations"

From makerspace.tulane.edu
Jump to navigation Jump to search
Line 2: Line 2:
  
 
==PLA==
 
==PLA==
 +
The default PLA material settings work, with one modification: after selecting the loaded material, go to the "Material" settings page, and then "Customize", and change the filament diameter setting to 3mm.
 +
 +
Apply glue stick to the print bed to facilitate PLA bed adhesion.
  
 
==ABS==
 
==ABS==

Revision as of 14:37, 29 September 2015

This page contains 3d printing configuration information specific to the Ultimaker 2. For preparing any print for this printer, make sure that you select "Ultimaker2" under "Machine" in Cura. If that option is not present, you may need to follow the Cura configuration instructions for this printer, or may need to install the latest LulzBot version of Cura.

PLA

The default PLA material settings work, with one modification: after selecting the loaded material, go to the "Material" settings page, and then "Customize", and change the filament diameter setting to 3mm.

Apply glue stick to the print bed to facilitate PLA bed adhesion.

ABS

Because of contraction due to cooling, ABS tends to lift away from the glass build plate. This is worse for square corners; round objects rarely lift. In Cura, specify a raft around your object. This way, the raft will (possibly) lift but your object may stay flat. When the build-plate is still cool, paint a thin layer of ABS paint (glass jar) onto the clean glass build plate. The dried ABS paint will further anchor your object to the build plate. Recommended settings are ......

HIPS