View source for FlexyDually Extruder TAZ 5

[[File:LulzBot-FlexyDually-Mounted.JPG|200px|thumb|right|Example Image of FlexyDually Dual Extruder]]
The LulzBot TAZ 5 with the FlexyDually extruder has the advantage that it is able to print two filaments at once: one being a standard, hard plastic filament, for example [[ABS]] or [[PLA]], and the other a flexible filament, such as a dissolvable support material, like [[PVA]], or a rubber-like flexible material, like [[NinjaFlex]].

Printing with this printer should be considered more advanced, and for most prints, the additional features are likely unnecessary. Additional configuration is necessary in [[Cura]] in order to properly use this printer.

Note that [[g-code]] prepared for the [[Hexagon Extruder TAZ 5]] will NOT behave the same on this printer. Prints will have to either be re-plated in [[Cura]] using the correct machine profile, or the [[g-code]] will have to be manually edited.

== Cura Configuration ==
Open the LulzBot version of [[Cura]] and follow the following steps:


Click the "Machine" drop-down menu and select "Add New Machine".

Select "LulzBot TAZ 4 or 5" and click next.

Select "Modified LulzBot TAZ 4 or 5" and click next.

Select "PEI" and click next.

Select "v1 (Budaschnozzle)" and click next.

Select "FlexyDually v1" and click next.

Click "Skip upgrade" and "Yes" on the warning that pops up.

Click "Finish".

== Recommended Print Configurations ==

== Diagnostic Procedures and Information ==