View source for FlexyDually Extruder TAZ 5

[[File:LulzBot-FlexyDually-Mounted.JPG|250px|thumb|right|Example Image of FlexyDually Dual Extruder]]
The LulzBot TAZ 5 with the FlexyDually extruder has the advantage that it is able to print two filaments at once: one being a standard, hard plastic filament, for example [[ABS]] or [[PLA]], and the other a flexible filament, such as a dissolvable support material, like [[PVA]], or a rubber-like flexible material, like [[NinjaFlex]].

Printing with this printer should be considered more advanced, and for most prints, the additional features are likely unnecessary. Additional configuration is necessary in [[Cura]] in order to properly use this printer.

Note that [[g-code]] prepared for the [[Hexagon Extruder TAZ 5]] will NOT behave the same on this printer. Prints will have to either be re-plated in [[Cura]] using the correct machine profile, or the [[g-code]] will have to be manually edited. Also note that the extruders on this printer have a maximum temperature of 240C, lower than the 300C maximum of the [[Hexagon Extruder TAZ 5]].

== Cura Configuration ==
Open the LulzBot version of [[Cura]] and follow the following steps:

*Click the "Machine" drop-down menu and select "Add New Machine".
*Select "LulzBot TAZ 4 or 5" and click next.
*Select "Modified LulzBot TAZ 4 or 5" and click next.
*Select "PEI" and click next.
*Select "v1 (Budaschnozzle)" and click next.
*Select "FlexyDually v1" and click next.
*Click "Skip upgrade" and "Yes" on the warning that pops up.
*Click "Finish".

== Recommended Print Configurations ==
[[FlexyDually Extruder TAZ 5 Print Configurations]]

== Technical Details ==
*0.5mm nozzle (both extruders)
*240C maximum extruder temperature (both extruders)
*120C maximum bed temperature
*PEI print bed
*Print Area: 298mm x 275mm x 250mm
*Top Print Speed: 200mm/sec

== Bed Leveling ==
The bed leveling procedure is the same as on the [[Hexagon Extruder TAZ 5]], with the exception that the leveling pattern has to be run for both extruders, and that different g-code files are required.

*Extruder 1 leveling pattern [[g-code]]: [FlexyDuallyE1BedLevel.gcode]
*Extruder 2 leveling pattern [[g-code]]: [FlexyDuallyE2BedLevel.gcode]
== Miscellaneous Notes ==