Digital-1 Training: Difference between revisions

From makerspace.tulane.edu
Jump to navigation Jump to search
Line 13: Line 13:
Read through the presentation linked below and complete the quiz at the end.
Read through the presentation linked below and complete the quiz at the end.


[https://tulane.box.com/shared/static/6sgnyp64eweitvwz1i8u4xpconxythj4.ppsx Digital-1 Presentation]
[https://tulane.box.com/s/8b09xps2ma8gp5tnnh0a884vzq81gcx6 Digital-1 Presentation]
 
[https://tulane.box.com/s/0rsfnvz8hcnhamvqg8nks8o96dcww0h0 Digital-1 Quiz]


===Step Two===
===Step Two===

Revision as of 19:38, 31 August 2017

This is the basic training for use of the simpler digital rapid prototyping tools. Completion of the Digital-1 training allows access to

Step One

Read through the presentation linked below and complete the quiz at the end.

Digital-1 Presentation

Step Two

Complete the following designs to demonstrate your ability to use the machines.

a) 3d Printer: Successfully set up and print Elwood the Robot on any of the 3D printers.

Elwood the Robot file

b) Laser cutter: Design and make a backpack tag like the one in the picture. Use a vector graphics software package (Illustrator, Corel Draw, Inkscape) to lay out the tag and then use the laser cutter to fabricate it from a small piece of scrap plywood. The slot for the plastic loop should have inside dimensions of 5mm x 15mm. When your tag is complete, ask the Ninja for a plastic loop.

Backpack Tag